Had to lift some T&G floorboards today, obvious job for the Bosch PMF180.

Used a plunge blade to cut the boards across the joists, then needed to cut
along the T&G.

Can be done with a plunge blade obviously, but the semi circular blade is
the way to go.

Plunged into the gap where the T&G was & pushed forward, when the blade met
a joist it rode over it because of its semi circular shape, then dropped
back down again!

Six foot length of floorboard about 20 seconds, no notches on joists, hardly
a scratch, board lifted cleanly - an almost perfect job with no real effort.

Shame the blades are so much money.


--
Dave - The Medway Handyman
www.medwayhandyman.co.uk