What determines what setting should be used for pump speed on a WB 24i
boiler?

I have googled but cant find a answer (aparts from dont adjust etc). At the
moment it is set to the slowest setting I and everything seem to be working
ok.

Should I adjust?

On Thu, 27 Dec 2007 15:42:02 +0000, Jim wrote:

I have googled but cant find a answer (aparts from dont adjust etc). At
the moment it is set to the slowest setting I and everything seem to be
working ok.

Should I adjust?

Absolutely. And open your microwave oven and poke around inside because
the warnings say not to :-)

--
John Stumbles

I used to think the brain was the most interesting part of the body
- until I realised what was telling me that

On Thu, 27 Dec 2007 15:42:02 +0000, Jim wrote:

What determines what setting should be used for pump speed on a WB 24i
boiler?

I have googled but cant find a answer (aparts from dont adjust etc).

That would be from the the Boiler Choice FAQ.


Speed Selector


Pumps usually have 2 or 3 speed settings leave well alone unless you know
what you are doing.


If the lowest speed works then enjoy the fact that your heating system
uses less electrical energy than it might otherwise.

--
Ed Sirett - Property maintainer and registered gas fitter.
The FAQ for uk.diy is at http://www.diyfaq.org.uk
Gas fitting FAQ http://www.makewrite.demon.co.uk/GasFitting.html
Sealed CH FAQ http://www.makewrite.demon.co.uk/SealedCH.html
Choosing a Boiler FAQ http://www.makewrite.demon.co.uk/BoilerChoice.html