Hi all, have bought basin with semi ped, no instructions just some
fittings and some springs, can anyone explain in detail (simple
detail ) how on earth i fit this to the basin, also the same applies
to the pop up waste supplied with the mono hole tap, no instructions
again, a diagram of both would be fantastic if possible , I thank you
in anticipation, t

Bod wrote:
Hi all, have bought basin with semi ped, no instructions just some
fittings and some springs, can anyone explain in detail (simple
detail ) how on earth i fit this to the basin, also the same applies
to the pop up waste supplied with the mono hole tap, no instructions
again, a diagram of both would be fantastic if possible , I thank you
in anticipation, t

Bit difficult to answer that without knowing exactly what you've got!
These things vary from model to model.

Why haven't you got any instructions - can't you hassle the supplier or
manufacturer?

David

On Sun, 9 Dec 2007 10:27:57 -0800 (PST), Bod wrote:

Hi all, have bought basin with semi ped, no instructions just some
fittings and some springs, can anyone explain in detail (simple
detail ) how on earth i fit this to the basin, also the same applies
to the pop up waste supplied with the mono hole tap, no instructions
again, a diagram of both would be fantastic if possible , I thank you
in anticipation, t

I have only had one w/h basin with a popup waste so if this one is the
same then a rod went in to a hole on tope of the monobloc tap and
connected to another rod that came out from a fitting in the waste
between the trap and the basin . The two were held together by a small
locking screw thingy . Pressing the rod on the tap down popped up the
waste when adjusted properly .
As for the rest of your query I cannot help .
Where did you get it . There surely must be instructions for this .Are
you sure you didnt throw them out by mistake .Get back on to the
suppliers and save yourself a load of grief.

Stuart