Hi,

I have to replace all the ceiling joists in my lounge following
ripping down the lathe & plaster and discovering that most of the
joists are considerably bowed in all different directions and won't
give me the flat finish I am after for the plasterboard.

On the party wall side the old joists are butted against a beam which
is attached to the brickwork. There is a small strip attached to the
beam that the joists sit on with a little piece cut out of the joists
to form a sort of step (sorry for the nontechnical terms). Rather
than having to cut this step out of all the new joists is it possible
to use galvinised steel hangers ? I would have to remove the step
strip, bend the hangers over the beam and nail them. The joists would
then sit in the hanger and be nailed themselves. Seems like a much
simpler solution to me.

Cheers,
David

David G wrote:

I have to replace all the ceiling joists in my lounge following
ripping down the lathe & plaster and discovering that most of the
joists are considerably bowed in all different directions and won't
give me the flat finish I am after for the plasterboard.

Before you pull your ceiling down althogether, how bowed are they? Could
you pack out with loads of bits of wood to make the surface relatively
flat, then allow the plasterboard to bend a tiny bit? You can also
improve things by putting the finishing skim on thicker in some places
than others. I have done this when replacing lath and plaster with
plasterboard in my house, and nobody notices (least of all me).

Ben.

"David G" wrote in message
om...
Hi,

I have to replace all the ceiling joists in my lounge following
ripping down the lathe & plaster and discovering that most of the
joists are considerably bowed in all different directions and won't
give me the flat finish I am after for the plasterboard.

On the party wall side the old joists are butted against a beam which
is attached to the brickwork. There is a small strip attached to the
beam that the joists sit on with a little piece cut out of the joists
to form a sort of step (sorry for the nontechnical terms). Rather
than having to cut this step out of all the new joists is it possible
to use galvinised steel hangers ? I would have to remove the step
strip, bend the hangers over the beam and nail them. The joists would
then sit in the hanger and be nailed themselves. Seems like a much
simpler solution to me.

Cheers,
David

Being very finicky David. All ceilings undulate and no matter how straight
it is when it is first installed, over the period of the first year of
working life it will bow and settle and crack and separate and all do all
the other things that working ceilings do. If I were you, I'd have a look
at the really bad bits on the existing joists and maybe pack them out a bit
to take most of the upward lift of some bits on the ceiling, but I wouldn't
go with replacing the whole thing. The existing joists are now weathered
and dried enough to stay in the best shape any joist system can be for your
property, so trying to make a perfect ceiling is quite literally impossible.
But don't let me put your off trying, who knows, you may just be the one who
does get it perfect.


---
http://www.basecuritysystems.no-ip.com

Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.515 / Virus Database: 313 - Release Date: 01/09/03