Home |
Search |
Today's Posts |
|
UK diy (uk.d-i-y) For the discussion of all topics related to diy (do-it-yourself) in the UK. All levels of experience and proficency are welcome to join in to ask questions or offer solutions. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to uk.d-i-y
|
|||
|
|||
Wirquin Dual Flush - how does it work ?
Hi - I bought and installed a Wirquin MW2 dual flush from B&Q
(http://www.wirquin.com/sitegb/accueilgb/indexgb.html). The problem is I don't think its working correctly. If I press either the half or full flush and let go it flushes about half the water in the cistern. If I press and hold either button then it flushes the whole cistern. The only difference I can see between the two buttons is that the full flush lifts the plunger thing (that sits over the hole into the pan) a little bit higher than the half. Does anyone else have any experience of these and how they're supposed to work ? TIA Peter |
#2
Posted to uk.d-i-y
|
|||
|
|||
Wirquin Dual Flush - how does it work ?
peterd wrote:
Does anyone else have any experience of these and how they're supposed to work ? We have one of these and it's doing the same thing... I *think* that what it's supposed to do is latch the release lever in the higher position when you press the button for full flush - but ours isn't doing and I've given up bothering Lee -- Email address is valid, but is unlikely to be read. |
#3
Posted to uk.d-i-y
|
|||
|
|||
Wirquin Dual Flush - how does it work ?
Lee wrote: peterd wrote: Does anyone else have any experience of these and how they're supposed to work ? We have one of these and it's doing the same thing... I *think* that what it's supposed to do is latch the release lever in the higher position when you press the button for full flush - but ours isn't doing and I've given up bothering Lee -- Email address is valid, but is unlikely to be read. Fixed it ! The white plastic bit with two prongs that lifts up the flap wasn't clipped in properly. Thanks Peter |
#4
Posted to uk.d-i-y
|
|||
|
|||
Wirquin Dual Flush - how does it work ?
peterd wrote:
Fixed it ! The white plastic bit with two prongs that lifts up the flap wasn't clipped in properly. On ours it doesn't seem to "latch" properly, sometimes it clicks into place but most often not - like I said can't be bothered it works just as well as push and hold Lee -- Email address is valid, but is unlikely to be read. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Grunt Work, Machines and Soul (somewhat long) | Woodworking | |||
repost - teahing kids woodworking - great story | Woodworking | |||
Online videos for dual flush toilet repair | Home Repair | |||
Plagiarism | Woodturning | |||
Electrical work - would inspector check previously done work? | Home Repair |