antgel wrote:

I've just removed some kitchen wall tiles with the SDS. I'm not
familiar with the construction of plasterboard. The adhesive on the
back of the tiles appeaers to have taken off the top layer of board,
leaving a brown surface a little like torn card (not gone through to the
plaster).

I'm hoping that this convoluted description will enable someone to tell
me if this can be painted straight onto, or if not, what treatment it
needs first. Surely it doesn't need skimming?

I am supprised you have not gone into the plasterboard centre since it
is not that tough! If not then well done ;-)

Depends a bit on what you want to do with the surface next. To get a
decent paint surface you could probably line it with lining paper first.
To re-tile you could give it a coat of dilute PVA and then get sticking.
It is is in a really poor state then sticking another thin sheet (9mm)
of plasterboard to it first would fix it.

--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/

In article , "antgel"
says...
John Rumm wrote:
antgel wrote:

I've just removed some kitchen wall tiles with the SDS. I'm not
familiar with the construction of plasterboard. The adhesive on the
back of the tiles appeaers to have taken off the top layer of board,
leaving a brown surface a little like torn card (not gone through to
the plaster).

I'm hoping that this convoluted description will enable someone to
tell me if this can be painted straight onto, or if not, what
treatment it needs first. Surely it doesn't need skimming?


I am supprised you have not gone into the plasterboard centre since it
is not that tough! If not then well done ;-)

There are places where I have, but these can be patched up easily.

Depends a bit on what you want to do with the surface next. To get a
decent paint surface you could probably line it with lining paper first.
To re-tile you could give it a coat of dilute PVA and then get sticking.
It is is in a really poor state then sticking another thin sheet (9mm)
of plasterboard to it first would fix it.

With regard to the lining paper, is this likely to look bad (or even
visible) once painted, if I only apply the paper where it's needed to
cover damage? Large parts of the wall are still fine.

Yes, it will look horrid.

Rob Morley wrote:

With regard to the lining paper, is this likely to look bad (or even
visible) once painted, if I only apply the paper where it's needed to
cover damage? Large parts of the wall are still fine.

My nesserver seems to have dropped this post....

Yes, it will look horrid.

If there is substantial marking to the plasterboard then yes it will
look pretty bad. However slight imperfections may be improved with paper.

Failing that give a quick coat of emulsion, and then use a wide taping
knife and a bag of artex as a fine surface filler to fix any blemishes.
Once dry sand again and then paint.

(Artex is a dirt cheap filler and sands easily when used like this)

--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/