I'll know shortly if my gas valve/operator is the cause of my boiler not firing
up. It's on an old Baxi Bermuda 551. The boiler pilot light is lit.

Q1: If the valve's ok, and it's just the operator that's died, can I replace it
without disturbing the gas path? (Put another way, does removing the operator
let the gas out?)

Q2: How to set the adjuster after remove/replace?

I did a quick Ohms test on the thermostat:
Off = open circuit.
On = about 1 Ohm (regardless of setting).

I'll check if power's getting to the valve.

Thanks

Edwin
Bath.