Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Miller Trailblazer 55G further updates.....
On Fri, 04 Jul 2008 18:16:09 -0700, Gunner Asch
wrote: Still couldnt get that Continental F-163 engine unfrozen, so had to pull the head....yes..it had at one point gotten water in it... http://picasaweb.google.com/gunnerasch/Miller55G Nothing seems to be badly damaged...but some valves appear to be frozen, as well as at least one piston..the worst is #1..the one with the fluid in the bottom of it in the above pictures. I left 5 studs broken off in the block getting the head off...but there are a fair number of threads standing above the block, that I can probably weld nuts on them and work them out...Crom..I hope so.. Any suggestions other than threading on nuts and then welding them on and hoping the heat loosens them up? I used a pick yesterday to clear some of the rust around them, and sprayed PBlaster in the gaps..along with the valves I took a chunk of wood, and a hammer and tapped each piston firmly, repeatedly spraying PBlaster around the sides of the pistons. Two of them appeared to not be frozen, the third (far right) may be so, but the far left one is still pretty much solid. Cylinder walls on the right one, is smooth, has no ridge, no scratches and is well polished, may have been honed at one point with a ball hone..or there is no wear at 2400 hours. Left cylinder has surface rust, not real thiick and a quick pass with a wire brush in a circular motion got down to polished wall . Down low...shrug..it may well be pretty pitted. At this point..I think Im going to have to put the machine up on blocks so I can drop the pan, disconnect the conn rods from the crank and drive out the pistons from the bottom....I dont think they will come out the bottom, will they? Ill get a fine wire wheel and wire "bob" and do the faces of the block and the head, and get out the crud and carbon from the various recesses. Unless someone has a better idea? Im not an engine guy...this is the 2nd or 3rd one Ive ever pulled down this far by myself, fortunately this is a stone simple engine Any suggestions at this point would be greatly appreciated Gunner Ugly, but seen worse. Above advice spot on, Get the block out & on a stand/bench. Get it stripped out and hot tank it. Possibly rig up a hyd jack/press over the stuck piston, .. Carefully press down on piston. Seen a brute bust out stuck pistons, try and avoid that.. ED |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Miller Trailblazer 55G update...sob.... | Metalworking | |||
Miller Trailblazer 55G update...sob.... | Metalworking | |||
Miller Trailblazer 55G update...sob.... | Metalworking | |||
Miller Trailblazer 55G? Help! | Metalworking | |||
Miller Trailblazer 301g 10,000 watt welder/generator - $3500 (Located in PHX) | Metalworking |