Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
O/A question
My new Harris O/A setup has the regulated oxygen guage scaled to 150 PSI.
Not much resolution when I am trying to set Oxy to 3-5 PSI "per the book" for small stuff. None of the charts the vendor gave me show a Oxy PSI above 60, most far below that. Is it common to change out the Oxy regulated pressure guage for something scaled lower ? thx, FF |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
OT Guns more Guns | Metalworking | |||
Yale Electric Chain Hoist Question | Metalworking | |||
Question about using a router | UK diy | |||
Plumbing Question | UK diy | |||
Question????? | Woodworking |