I'm in Toronto here. I've got around 3000? bimetal powerhacksaw blades that
I want to get rid of. They vary in length from 12" to 24" long and width
from 5/8" to 2". T.P.I.'s in smaller blades are 10 or 14 and in the larger
sizes 4, 6 and 4-6 variable pitch.

I'm going to get back in the shop tomorrow to clean up the boxes and
inventory this stuff and stick 'em up real high where nobody will trip over
them for the next ten years but before I inventory them I'd thought I'd post
a message here to see if there is something you want (hopefully lots).
Anywhere in GTA is fine. I'll prolly put these on EBay sometime this
spring but for now just want to clean up. Looking for 1 to 3 dollars a
blade depending on the width but not interested in selling one or two at a
time.

BTW the majority of these blades are 18-4-1 (German standard?) chrome
vanadium or M42. Dunno if they'd be too brittle for certain applications or
not. Infact I was thinking of taking a stubby cobalt drill and try to drill
thru them with the press just to experiment (with fluid of course)

If you are interested in knowing quantities or what the inventory was send
me an email to

HeadHunter.

On Thu, 20 Jan 2005 19:46:52 -0500, "HeadHunter"
wrote:

I'm in Toronto here. I've got around 3000? bimetal powerhacksaw blades that
I want to get rid of. They vary in length from 12" to 24" long and width
from 5/8" to 2". T.P.I.'s in smaller blades are 10 or 14 and in the larger
sizes 4, 6 and 4-6 variable pitch.

I'm going to get back in the shop tomorrow to clean up the boxes and
inventory this stuff and stick 'em up real high where nobody will trip over
them for the next ten years but before I inventory them I'd thought I'd post
a message here to see if there is something you want (hopefully lots).
Anywhere in GTA is fine. I'll prolly put these on EBay sometime this
spring but for now just want to clean up. Looking for 1 to 3 dollars a
blade depending on the width but not interested in selling one or two at a
time.

BTW the majority of these blades are 18-4-1 (German standard?) chrome
vanadium or M42. Dunno if they'd be too brittle for certain applications or
not. Infact I was thinking of taking a stubby cobalt drill and try to drill
thru them with the press just to experiment (with fluid of course)

If you are interested in knowing quantities or what the inventory was send
me an email to

HeadHunter.

You might try posting this on rec.knives. The folks make knives out of
them

Gunner

"Gunner, you are the same ridiculous liberal f--k you ever where."
Scipio