Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Weldon model 200 sharpener manual needed
Last week I bought a tool and cutter grinder from a poster to this NG.
It was a good deal and as always all dealings I've had with posters to this NG have been positive. The Weldon endmill sharpener it came with has a manual but it's a poor copy and illegible in many spots. I was told this up front and am not complaining but if anybody here has a manual they could scan and e-mail or fax to me I would appreciate it. I can buy one for 30 bucks but I've been spending money like water the last couple weeks and anyway the only way to get it is by snail mail. I have to send a check and then they will mail it. No credit cards and no 2nd day fedex or ups. And I'd like to sharpen some cutters this week Thank You, Eric R Snow |
#3
|
|||
|
|||
Thanks Keith,
I looked at his site and sent an e-mail. Eric |
#4
|
|||
|
|||
Thanks Keith,
I looked at his site and sent an e-mail. You're welcome. Good luck! Best Regards, Keith Marshall "Even if you are on the right track, you'll get run over if you just sit there." - Will Rogers (1879-1935). |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Boyar-Schultz Model 612 help needed | Metalworking | |||
Manual for a Shizuoka AN-S mill needed | Metalworking | |||
Needed: Sencore Super Cricket Service Manual | Electronics Repair |