I have a Ranger 8 that has been sitting in enclosed building for several
months. it was working fine when I took it off old truck for storage.
Well board went out in one I was using and had to put this one on truck
and it only wants to put out small amount of voltage now. could brushes be
dirty from moisture from just sitting. Everything else shows circuits are
good and no burnt wires with meter.With grinder plugged in it turns real
slowly and with light plugged in it is very dim. Machine idles up and down
as usual but no full power. All help would be appreciated.

--
posted from
http://www.polytechforum.com/metalwo...ng-601671-.htm
using PolytechForum's Web, RSS and Social Media Interface to
rec.crafts.metalworking and other engineering groups