Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
milling 17-4PH stainless
RE. my last post on buying carbide end mills.
THe job I was doing when I killed the two 3/4" x 2.25" LOC carbide ends mills was milling a slot in 17-4PH annealed stainless. About 32 Rockwell C. First end mill was run at S651 F4.67 really badly chipped after first piece. Second one was run at S300 F3.10 I got throught 1/2 a slot when I got a X-axis overload. It had started to pull the part up out of the vise and was cutting in deeper. Finished that part and the last one with a HSS end mill, uncoated, at S212 F1.49 and it worked nicely, but alittle slow. Job is done, but why was I killing end mills? First end mill was run at speed and feed I found for a carbide finish end mill. Second F&S was from a table in an OSG book for carbide roughers. 4" round bar clamped tight as hell in a kurt vise with 3" tall jaws. Remove 333 to reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Stainless steel nuts galling on stainless steel bolts | Metalworking | |||
Milling on the lathe Vertical tslot table or vertical milling vise? | Metalworking | |||
Milling bit on E-Bay | Metalworking | |||
Musing about up milling, down milling, shearing and scraping. | Woodturning | |||
FA 'A treatsie on milling and milling machines' | Metalworking |