 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#5
Posted to rec.crafts.metalworking
|
|||
|
|||
Perils of Sieg X3 (Quill DRO scale mounting)
On 2/24/2010 16:07, Mark Rand wrote:
My point was more along the lines that a boring head will to a better job of an 18mm clearance hole than either of the end mills. To be clear, I was milling pockets that the magnets will fit into that will pull the scale display unit. These pockets are not thru, just very close. IIRC, aluminum will not block the magnetic attraction all that much. I hope... |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| External Snapring for Sieg X3 Quill | Metalworking | |||
| Remote mounting of Sieg X3 small mill motor controls | Metalworking | |||
| Repeatability of Mill Quill DRO (Digital Scale) | Metalworking | |||
| Mounting DRO Scale | Metalworking | |||
| Mounting a Mill-drill (Quill) DRO (Digital caliper) | Metalworking | |||
Threaded Mode
