 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Perpendicular shank use in boring head
I'm perplexed. How does one orient the boring tool in the horizontal
hole of a boring head? The normal relief angle does not seem to be available... |
|
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
|
Perpendicular shank use in boring head
On Jul 29, 11:47*am, Louis Ohland wrote:
* *I'm perplexed. How does one orient the boring tool in the horizontal hole of a boring head? The normal relief angle does not seem to be available... I bored several meter holes in a panel that way last night, after cutting most of the metal out roughly with the nearest size of hole saw. With the cutting corner down the spindle had to run in reverse. jsw |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| FA: some small DC motors, and a CAT 40 holder and an R-8 boring head | Metalworking | |||
| Boring head dumb question | Metalworking | |||
| Import Boring Head Differences (If Any) | Metalworking | |||
| What is the croos hole of a boring head for? | Metalworking | |||
| Boring head setup? | Metalworking | |||
Linear Mode
