Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
fs: who was it that wanted a 3 phase reversing switch?
I just picked up a 6 pole triple throw switch rated 150 amp 600VAC - Krause
& Mamier C125 - it shows t used on 15 to 50 HP motors (more HP at higher voltage) three phase, and 7.5 to 30 HP motors single phase - it is a rotary switch ten inches long with a small "logic" switch on the very end - it came off of a large UPS, so the faceplate is marked "auto, Byp, and Test" - this ought to meet the need of whomever was asking - I'll list it on ebay later if no one contacts me about it - if you want it, $15 plus shipping (I expect it will bring a lot more than that if I list it on ebay, but you guys can have first crack at it) - to find me, go to my web site, below, and then just look for my email address. -- Bill www.wbnoble.com |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
who was it that wanted a 3 phase reversing switch?
I think Gunner just asked about this
|
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
who was it that wanted a 3 phase reversing switch?
"Karl Townsend" wrote:
I think Gunner just asked about this I thought he wanted reversing relays. Wes |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Three phase switch for single phase? | Metalworking | |||
Help to connect reversing switch to a motor | Metalworking | |||
Advice wanted on static self starting phase converter for a 2HP motor. | Metalworking | |||
Diagnosing reversing trigger switch on drill | Electronics Repair | |||
Wiring 3 phase switch for 2 phase power | Metalworking |