Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
mig stainless
For miging 304 stainless would 100% argon or 100% CO2 be better. The
CO2 welds much nicer, deeper pen. but is there some corrosion problems. These are the 2 gases I have and I am not getting the proper tri-mix. I am not looking for nice appearance, just no rusting. Even slight surface rust is ok. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
BBQ...and Quality Stainless | Home Repair | |||
Stainless steel nuts galling on stainless steel bolts | Metalworking | |||
FS - 304 stainless | Metalworking | |||
stainless rods | Metalworking | |||
Most magnetic stainless? | Metalworking |