Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
John Husvar
 
Posts: n/a
Default How to make a lot level

Harry Conover wrote:
Gary Coffman wrote in message . ..


The Egyptians didn't have garden hose. They dug trenches, filled them
with water, and measured off the water surface. For work too high above
ground level to conveniently reference off water in a surface trench, they
erected troughs or connected two basins with clay pipe.



That must have been a bit of a trick out in the middle of the desert!

Where did all that water originate?


Maybe denial isn't a river in Egypt, but Da Nile is.

Really, they had to have had water for the workers to drink anyway, so
they likely had enough extra around to set up a few bowl or trough levels.

  #2   Report Post  
Bob Powell
 
Posts: n/a
Default How to make a lot level


That must have been a bit of a trick out in the middle of the desert!

Where did all that water originate?


Maybe denial isn't a river in Egypt, but Da Nile is.

Really, they had to have had water for the workers to drink anyway, so
they likely had enough extra around to set up a few bowl or trough levels.



4000 years ago it was a lush green agricultural paradise. Today's desert
(in the valleys of the pyramids at least) is some combination of natural
events and poor farming, grazing and forest practices ...


  #3   Report Post  
Old Nick
 
Posts: n/a
Default How to make a lot level

On Sun, 02 May 2004 17:25:49 GMT, John Husvar
vaguely proposed a theory
.......and in reply I say!:
remove ns from my header address to reply via email

All the stuff left over by dead workers....

Really, they had to have had water for the workers to drink anyway, so
they likely had enough extra around to set up a few bowl or trough levels.


************************************************** **
The Met Bureau is LOVE!
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
OT-John Kerry Gunner Metalworking 137 February 11th 04 07:38 PM
How do I make a milling cutter holder gadget jt Metalworking 8 December 4th 03 09:07 PM


All times are GMT +1. The time now is 01:29 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"