Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1   Report Post  
Posted to rec.crafts.metalworking
Glenn
 
Posts: n/a
Default Garage heat with a 9.6 kW electric heater

I have a 20X20 detached garage with no insulation (paneled inside .. no
sheetrock) and a lousy seal on the big door. I run a 4.5KW electric heater
when I want to be comfy. If it is 40F out there and I plug it in then I am
comfortably warm 60ish in about 15-20 min. In an hour I am taking off my
quilted flannel shirt I have anti fatigue mats on the floor that help
keep the feet warm. I do set it so it points at the area I will be working
in. It rarely gets below 30F during the day here.
I would just set the duct heater on the floor and fire it up to see if it
heats well enough to be made fancy.
Glenn
"Ignoramus24987" wrote in message
...
I have a approximately 20x20 ft attached garage. Sometimes I want to
make it warm quickly. Often I am there for relatively short periods of
time (because I am constantly interrupted).

I bought a 9.6 kW, 240V duct heater on ebay. It has a 24V control and
various overheat protections.

My plan is to enclose it into a welded frame and sheet metal (found a
few nice sheets in a hospital dumpster), add a fan to it and a 24V
control system using a thermostat. I also have a grill type thing that
I can use to protect the coils from little curious fingers and
flammables.

My idea is to make something relatively compact (say 2x2x1.5 ft), that
I would set on the floor, turn on and get the garage warm in a few
minutes rather than wait for a long time. I would save some
electricity by only heating the garage when I need it, rather than
warming it up "just in case".

What I am looking for is some feedback on safety and such.

i



 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Garage heat with a 9.6 kW electric heater spaco Metalworking 0 December 30th 05 06:54 PM
Which is more economical - electric or natural gas water heater? daestrom Home Repair 0 December 4th 05 02:58 PM
Above ground pool heaters - Gas heater vs. Electric heat pump ack123 Home Ownership 1 June 15th 05 04:39 PM
Power cost of idle electric water heater Phil Sherrod Home Repair 57 April 2nd 04 10:51 PM
Electric Heater Denver Woody Woodworking 6 October 2nd 03 09:43 PM


All times are GMT +1. The time now is 11:58 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"