Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
PULLEY MEASUREMENT
Another dumb question......Is the diameter of a pulley measured by the
overall outside diameter or the smaller inside diameter where the bottom of the belt rides? |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
PULLEY MEASUREMENT
|
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
PULLEY MEASUREMENT
flyfisher wrote:
Another dumb question......Is the diameter of a pulley measured by the overall outside diameter or the smaller inside diameter where the bottom of the belt rides? Outside. Technically, it's the "pitch diameter" but everyone just measures the OD. You can easily see this at the hardware store, measure a 2-3-4" step pulley and you'll see the OD of the small end is 2", big end 4" .. GWE |
#4
Posted to rec.crafts.metalworking
|
|||
|
|||
PULLEY MEASUREMENT
"Grant Erwin" wrote in message ... flyfisher wrote: Another dumb question......Is the diameter of a pulley measured by the overall outside diameter or the smaller inside diameter where the bottom of the belt rides? Outside. Technically, it's the "pitch diameter" but everyone just measures the OD. You can easily see this at the hardware store, measure a 2-3-4" step pulley and you'll see the OD of the small end is 2", big end 4" .. GWE Just a side comment... The bottom of the vee is meaningless... If the belt were to "bottom out," it would slip. Jerry |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Removing the drive pulley from my MTD Yardbug | Home Repair | |||
pulley ratio / replacement motor question | Woodworking | |||
Maytag pulley removal? | Home Repair | |||
Figuring loads / block & tackle theory | Home Repair | |||
urgent-getting arbor pulley off of Jet table saw | Woodworking |