 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
? Phase II 4 jaw chuck
Travers has a 6 inch 4 jaw chuck that I am interested in. My lathe is a Jet
9X20 with a 1 1/2 inch spindle. The 4 jaw has a 1 1/2 through hole and I am wondering if there is any chance of interference when I put a back on it. I assume (I know) that the back will be thick enough to keep the chuck away from the spindle. Or should I not be concerned. Bill k7NOM |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| My $45 homemade 10 HP phase converter is WORKING!!! | Home Repair | |||
| My lathe's spindle is too long for my new chuck | Woodturning | |||
| Motor capacitor sizing? | Metalworking | |||
| Teknatool Titan Chuck draft review | Woodturning | |||
| Phase converter balancing | Metalworking | |||
Threaded Mode
