 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Tapmatic Tool Changer 80-381 Help Needed
I have a Tool Changer, Model 80-381, that was made by Tapmatic, Costa
Mesa, CA. It is also marked JAHRL, Orebro, Sweden. It has an R-8 shank and the head is a quick change for collets which thread into tool head and are held by ball detent and centered with a taper. The 1/2" end mill holder is marked JAHRL 80-381-H1/2" . The short collet holder is marked JAHRL 80-381-CH 10. Anyone know if these are still supported or have any information about this tool system? |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Dremel Multi Tool or Cheaper alternative? | UK diy | |||
| which way round to use ratchet crimping tool? | UK diy | |||
| This new cutting tool allsaw 150, anyone used it yet? | UK diy | |||
| Basics on Depth of Cuts | Metalworking | |||
| How to grind lathe bits on HF carbide tool grinder? | Metalworking | |||
Linear Mode
