When I just finished my trommel, I had a gear reduction motor that I
used. Apparently, it had never been used, as there was no oil in it,
and I do mean DRY. I put some 30 wt in there, what I had. I have used
it about four hours now. Should I put any special oil in there, and if
I do switch oils, do I need to flush the old oil out, and with what?

Steve

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gear puller for DC cordless drill motor gear?	John Doe	Metalworking	9	February 27th 16 08:33 AM
Airboat reduction gear	mark	Metalworking	31	April 3rd 09 04:24 PM
fa: somebody was looking for a gear reduction assembly to make a metal cutting band saw	William B Noble (don't reply to this address)	Metalworking	0	March 2nd 06 06:34 AM
Rotational to Linear Gear Reduction calculation	gtslabs	Metalworking	9	February 25th 06 10:41 PM
What is behind a 6:1 reduction gear on a Briggs Intek 6.5?	[email protected]	Metalworking	8	March 16th 05 09:33 PM

All times are GMT +1. The time now is 10:12 AM.

About Us

"It's about DIY & home improvement"

Menu

About Us