I recently was given 9 advance ballast IZT-3S32-SC. These are dimming
ballasts for 2 lamps. Can they be used with just two lamps like some where
you just don't use one of the wires? Also, I have googled and cannot figure
out if the purple and grey wire have to have voltage on them to fire the
lamps or not. I think from what I have read, that to get 100% output, you
have to put 10V dc on them but I am not sure. If this is true, where do you
get the 10V? Anyone have any experience with them?
Here is a link to the Spec Sheet
http://www.usa.lighting.philips.com/.../IZT3S32SC.pdf
Thanks,

Roanin

"Roanin" wrote in message
...
I recently was given 9 advance ballast IZT-3S32-SC. These are dimming
ballasts for 2 lamps. Can they be used with just two lamps like some where
you just don't use one of the wires? Also, I have googled and cannot figure
out if the purple and grey wire have to have voltage on them to fire the
lamps or not. I think from what I have read, that to get 100% output, you
have to put 10V dc on them but I am not sure. If this is true, where do you
get the 10V? Anyone have any experience with them?
Here is a link to the Spec Sheet
http://www.usa.lighting.philips.com/.../IZT3S32SC.pdf
Thanks,


You need a source of 0 to 10 volts. This can come from a dimmer similar to
this one.

http://1000bulbs.com/product/89553/LUT-NTFTVBL.html