We purchased our PWC863000, pressure washer through Sam's Club
auction. When received, it appeared the shipping container had been
previously opened, so the problem may reside with them, rather than
Powermate Corp., now sold by Praymac Industries.

There was nothing in the shipping box and packages that resembled
anything like assembly instructions. I registered the unit on the
company's website and while there looked for an answer, but could not
find any manuals relating to this model, so I suppose it must be a
discontinued one.

By looking at the pictures on the box and the parts diagram, I was
able to assemble the unit and I would like to begin using it, BUT... I
have 2 bolts left over, and cannot figure out where they belong, or
what I should do with them. They are both the same; black, pan head,
1/4 by 1 1/4 inch, 18 tpi, and the head requires an Allen-wrench to
tighten.

Can any of you tell me what these two bolts are used for or where they
go?

Thanks for your advice.
Lee

replying to Lee, Jess Pettit wrote:
I realize this post is 12 years old. I have this pressure washer and it has
been great. Mine came pre-assembled (incorrectly BTW). These type bolts
typically are used to fasten the pressure pump to the crankcase of the Honda
GC190 engine and a total of 4 are required. I have complete service, routine
maintenance and owner's manuals for the pump and engine. If you ever have
other questions regarding recommended maintenance or want to sell the unit,
let me know.

--
for full context, visit https://www.homeownershub.com/mainte...er-333337-.htm