Home |
Search |
Today's Posts |
|
Home Repair (alt.home.repair) For all homeowners and DIYers with many experienced tradesmen. Solve your toughest home fix-it problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to alt.home.repair
|
|||
|
|||
Water Heater air gap, below T&P valve
Does there really have to be a full 6" gap betwen the bottom of the
T&P discharge pipe and the floor? I don't see the purpose of it. The instructions that came with the water heater say to leave a 6" air gap between the temperature and pressure pipe and the floor drain. The water heater that was first installed in the house was like that too. I have a pan under the WH and if the discharge pipe came to within an inch or two of the pan, I think more of the water would go into the pan when I lifted the T&P lever. And less on the floor. |
#2
Posted to alt.home.repair
|
|||
|
|||
Water Heater air gap, below T&P valve
"mm" wrote in message ... Does there really have to be a full 6" gap betwen the bottom of the T&P discharge pipe and the floor? I don't see the purpose of it. The instructions that came with the water heater say to leave a 6" air gap between the temperature and pressure pipe and the floor drain. The water heater that was first installed in the house was like that too. I have a pan under the WH and if the discharge pipe came to within an inch or two of the pan, I think more of the water would go into the pan when I lifted the T&P lever. And less on the floor. Be aware that, if the T&P valve should ever be called on to do what it is intended to do, what comes out of the pipe is a tremendous blast of boiling water and steam. Whether it goes into the pan first or directly on the floor would not matter much. The six inches is intended to ensure that the heater be vented as rapidly and safely as possible, and also to minimize any possibility that the water in the heater could ever be contaminated by drain or ground water. I agree that it is nice to understand the reasons for code requirements, but if you do not understand the reason that is all the more reason to comply since there is obviously something you haven't thought of. Codes are primarily for safety, after all. Don Young |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Check valve for water inlet on hot water heater ? | Home Repair | |||
Water Heater Install: Replace gate valve with ball valve | Home Repair | |||
Water heater TPR Valve opening at about 160*F? | Home Repair | |||
Hot water heater valve | Home Repair | |||
Water heater relief valve -- POW! | Home Repair |