I had a new water heater installed about a year ago. I have noticed
that over the course of the year the pressure has gotten worse to the
point that in the bathroom furthest from the hot water heater there is
barely any pressure coming from hot water in bathtub. When they
installed the new water heater they added a valve on the inlet side of
the water heater. Is it possible that this valve is either corroded
with sediment or bad all together. Please any help would be appreciated.

"Mike" wrote in message
oups.com...
I had a new water heater installed about a year ago. I have noticed
that over the course of the year the pressure has gotten worse to the
point that in the bathroom furthest from the hot water heater there is
barely any pressure coming from hot water in bathtub. When they
installed the new water heater they added a valve on the inlet side of
the water heater. Is it possible that this valve is either corroded
with sediment or bad all together. Please any help would be appreciated.


If the valve is blocked it would effect all your fixtures not just one.
So are all the fixtures losing pressure ? ( your actually loosing volume)
Did they install new dielectric nipples? they look like a 3/4" galvanized
nipple screwed directly into the water heater. If so some have a built in
check valve, This could be causing a problem could be stuck. If it is just
the bathroom it could be sediment is stuck in the fixture. Allot of times
when you work on a plumbing system crap gets in the lines.

Thank you for the fast reply. All of the fixtures have lost pressure.
The ones on the far side of the house are just the worst.

Anymore input would be greatly appreciated

"Mike" wrote in message
oups.com...
Anymore input would be greatly appreciated


It could be allot of things. Is the house copper or galvanized pipe ? Old
galv. gets
corroded and blocks the water. That would be a major repair. It could be
the valve they installed. Have you tried opining and closing it a couple
times? Maybe close the inlet valve drain some water out of the tank try
opining and closing the valve a couple times Might free something up. If
it's a gate valve sometimes the stem breaks You will know if it just keeps
spinning.

There is crud in the lines before the valve. You can tear out the valves and
flush or use my handy "back flush" system.

1. Turn off power or gas to hot water heater.
2. Turn off cold water valve supplying cold water to the hot water heater.
3. Connect garden hose (going outside) to water heater drain and open drain.
4. Go to bathtub, place a cap or one of those shower on/off valves on the
shower. Turn center valve so water is directed to shower instead of tub.
5. Fully open cold and hot water valves for shower.
6. Let flow for about 10 minutes.
7. Do same with faucets, except you can't easily cap them, so hold rag over
faucet.

What you are doing is getting the cold water to flow in one end of the
faucet then flow back out the hot water side. And hopefully this will also
move the crud back to the hot water heater, and out the drain. i.e. back
flushing the hot water pipes.

"Mike" wrote in message
I had a new water heater installed about a year ago. I have noticed
that over the course of the year the pressure has gotten worse to the
point that in the bathroom furthest from the hot water heater there is
barely any pressure coming from hot water in bathtub. When they
installed the new water heater they added a valve on the inlet side of
the water heater. Is it possible that this valve is either corroded
with sediment or bad all together. Please any help would be appreciated.