Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #9   Report Post  
NSM
 
Posts: n/a
Default


"Asimov" wrote in message
...

One thing I've discovered about laser pointers is that the chip area
is purposely constructed so that it is impossible to collimate the
beam to make it into a dangerous device. What I think happens is that
there are multiple lasing areas which are slightly out of phase with
each other. When one tries to concentrate the beams onto a very tiny
spot they tend to subtract from each other and cancel out.

I suspect that if the 'point' was finer it would make a worse pointer.

N


 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Setting angles of a compound using laser pointers Jacek Zagaja Metalworking 1 December 3rd 04 04:14 AM
Laser level??? Sorta........ Tom Metalworking 9 December 30th 03 10:19 AM
Argon Laser, 150mW, American Laser Spudley Electronics 0 October 3rd 03 06:19 AM
JDS Uniphase SLM uGreen 532 nm DPSS Laser problems Sam Goldwasser Electronics Repair 0 July 15th 03 03:50 PM
Laser Epilation. Pauline Aston Electronics 1 July 6th 03 09:15 PM


All times are GMT +1. The time now is 08:04 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"