Home |
Search |
Today's Posts |
![]() |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
LinkBack | Thread Tools | Display Modes |
#1
![]()
Posted to sci.electronics.repair
|
|||
|
|||
![]()
Hi. I have am pm3384 and it's been a fine machine for me. Recently I ran into an issue with the cursors. They aren't accurate to the displayed waveform at all. I tried to use autocal and it failed with error code d1a. I read the service manual, which makes no reference to this error code or any for that matter, and performed a manual calibration. Well long story short it still failed and was wondering if anyone is familiar with d1a?
Thanks |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Tektronix 2467B Oscilloscope Error Codes | Electronics Repair | |||
Strange focus error on Oscilloscope Hameg HM1005 | Electronics Repair | |||
Loking for Autocal-users | Electronic Schematics | |||
Tektronix 2467B (similar to 2465B): Error Message TEST 04 FAIL 13 (3453) | Electronics Repair | |||
Tektronix 2467B (similar to 2465B): Error Message TEST 04 FAIL 13 (3453) | Electronics Repair |