Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
AKAI GX-75 Biasing problem
Hello everybody,
does someone meet similar problem like that: in a CALIBRATE MODE You can not adjust Bias value as much as is necessary (value is too small). "Level" is OK and it is adjustable. Does problem lie in the magnetic head? I have tried readjust semi pots inside the deck, clean heads, demagnetize heads, adjust tape path, azimuth etc, deck works just a little better, but not as good as it could and with too small bias. Best regards. Robert |
#2
|
|||
|
|||
AKAI GX-75 Biasing problem
Shot in the dark, but are you using the correct tape for the bias setting
(switch). -- change .combo to .com for correct email ************************************************** * "We ought always to know precisely why a given job is done in a particular way, and why it is done at all, and why it can't be done more efficiently, if it must be done at all."-- T.J.Watson ************************************************** * "Robert Majerić" wrote in message ... Hello everybody, does someone meet similar problem like that: in a CALIBRATE MODE You can not adjust Bias value as much as is necessary (value is too small). "Level" is OK and it is adjustable. Does problem lie in the magnetic head? I have tried readjust semi pots inside the deck, clean heads, demagnetize heads, adjust tape path, azimuth etc, deck works just a little better, but not as good as it could and with too small bias. Best regards. Robert |
#3
|
|||
|
|||
AKAI GX-75 Biasing problem
Kevin Carney wrote in message ... Shot in the dark, but are you using the correct tape for the bias setting (switch). -- change .combo to .com for correct email ************************************************** * "We ought always to know precisely why a given job is done in a particular way, and why it is done at all, and why it can't be done more efficiently, if it must be done at all."-- T.J.Watson ************************************************** * YES, Auto Tape Selector Switches works well ))) |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
jointer problem | Woodworking | |||
Boiler Problem Gradually Getting Worse | UK diy | |||
CRT Contrast Problem | Electronics Repair | |||
Sears air compressor starting problem | Woodworking |