Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
CD laser assembly replacement on the cheap
Hmm, occasionally I attempt to replace either a laser or complete
laser/motor assembly using cheap generic parts, and it just doesn't work. Today I recieved 2 x KSM213CCM to replace the ones in a Tascam dual CD player - DJ type thing with separate remote with pitchbend faders etc. One works fine, the other doesn't. It clicks, jumps and pops, and sometimes takes a while to recognise the disk. (This particular Tascam unit has a built in anti-shock data buffer) These KSM units contain the laser assembly, the 2 motors and all the gearing, to move the laser and spin the disc. I've tried swapping both complete mechs around, and also swapping the KSM units from one loading mech to the other. Whatever combination/side I try, the fault is always with the same new KSM unit. (I made sure the right mounting springs went back in the right place - one pair are silver, the other gold) Now these KSM assemblies are really, really cheap off ebay. They have to be or this just would not be an economical repair. (You can change both within half an hour) They are so cheap that I would expect one or two to be DOA on occasion, but this seems to happen too often. Last time it was another KSM213C that wouldn't behave. (I am always very careful in handling these things, I never touch any of the delicate laser parts/electronics, until they are seated in the loading mech and the flexible cable plugged into the laser PCB. It is only then I remove the safety short with desolder braid) So, a couple of questions. I assume the laser power preset is adjusted during manufacture and should not need adjusting after fitting. (I tried turning a few degrees either way, it did not help) Could there be some kind of incompatibility with the Tascam player (does it need its firmware settings readjusted somehow?) Are these things really just plug and play? Are these cheapo things often DOA or maladjusted/untested etc? Have I missed anything else? Cheers, Gareth. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Ideal Icos HE18 Fan assembly replacement | UK diy | |||
Any recommendations for (or against) cheap laser levels? | UK diy | |||
grinding KSS-240a laser assembly | Electronics Repair | |||
Cheap laser line for tiling ? | UK diy | |||
Playstation 2 laser assembly available from electronic suppliers? | Electronics Repair |