Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Service information for NAD 514 CD player needed!
Hello,
Before you start playing with adjustments, I would suggest cleaning the sled rails and lens as suggested by other posters. There is also a common problem with the focus coil drive transistors because an under-sized transistor was used. (This problem also occurs in the 5000 and 5440) Replace Q102 with a 2SD669 or similar transistor, and replace Q103 with a 2SB649 or similar. Also look for overheated solder joints in the area of the transistors. Regards, Tim Schwartz Bristol Electronics Gyro wrote: Hi guys. I'm searching for the above since the player has started skipping towards the end of a CD (tracking offset problem?). The board is rev. issue 1A and there are five potentiometers; VR101, 102 to 105. Which one solves the tracking problem? Any help appreciated :-) Andreas |
#2
|
|||
|
|||
Service information for NAD 514 CD player needed!
Hi guys.
Thanks very much for the suggestions. I forgot to write that I have already cleaned the lens; it didn't "look" dirty at all, so I assuming it's another problem. It there an easy way of ridding the player of the skipping? It usually begins halfway through a normal length CD. Thanks again for the help :-) Andreas "Tim Schwartz" wrote in message ... Hello, Before you start playing with adjustments, I would suggest cleaning the sled rails and lens as suggested by other posters. There is also a common problem with the focus coil drive transistors because an under-sized transistor was used. (This problem also occurs in the 5000 and 5440) Replace Q102 with a 2SD669 or similar transistor, and replace Q103 with a 2SB649 or similar. Also look for overheated solder joints in the area of the transistors. Regards, Tim Schwartz Bristol Electronics Gyro wrote: Hi guys. I'm searching for the above since the player has started skipping towards the end of a CD (tracking offset problem?). The board is rev. issue 1A and there are five potentiometers; VR101, 102 to 105. Which one solves the tracking problem? Any help appreciated :-) Andreas |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Ryobi - lousy local warranty service, no parts in stock? | Woodworking | |||
Screwfix spam news | UK diy | |||
Help - bathroom fitting information needed!? | UK diy | |||
Gas boiler service review/advice | UK diy |