Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
Denon Schematic anyone ... ?
Anybody got schems for a Denon PMA 255UK or similar model ?
Cheers Arfa |
#2
Posted to sci.electronics.repair
|
|||
|
|||
Denon Schematic anyone ... ?
"Arfa Daily" wrote in message
... Anybody got schems for a Denon PMA 255UK or similar model ? Cheers Arfa Not finding one... Mark Z. |
#3
Posted to sci.electronics.repair
|
|||
|
|||
Denon Schematic anyone ... ?
"Mark Zacharias" wrote in message ... "Arfa Daily" wrote in message ... Anybody got schems for a Denon PMA 255UK or similar model ? Cheers Arfa Not finding one... Mark Z. No, I couldn't either. And it's a strange fault, and it says on the job ticket "Advise before going ahead" which says that the owner is not going to want to shell out the amount of labour cost to try and find the problem without the benefit of schematics. I asked the store that took it in, and they confirmed that the owner "didn't want to spend a lot" so I will leave it this coming week in case a schematic comes to light, and then send it back with an 'inspection only' fee attached ... Arfa |
#4
Posted to sci.electronics.repair
|
|||
|
|||
Denon Schematic anyone ... ?
"Arfa Daily" wrote in message
... "Mark Zacharias" wrote in message ... "Arfa Daily" wrote in message ... Anybody got schems for a Denon PMA 255UK or similar model ? Cheers Arfa Not finding one... Mark Z. No, I couldn't either. And it's a strange fault, and it says on the job ticket "Advise before going ahead" which says that the owner is not going to want to shell out the amount of labour cost to try and find the problem without the benefit of schematics. I asked the store that took it in, and they confirmed that the owner "didn't want to spend a lot" so I will leave it this coming week in case a schematic comes to light, and then send it back with an 'inspection only' fee attached ... Arfa What is the general type of unit and the fault? It's an amplifier, yes? mz |
#5
Posted to sci.electronics.repair
|
|||
|
|||
Denon Schematic anyone ... ?
"Mark Zacharias" wrote in message ... "Arfa Daily" wrote in message ... "Mark Zacharias" wrote in message ... "Arfa Daily" wrote in message ... Anybody got schems for a Denon PMA 255UK or similar model ? Cheers Arfa Not finding one... Mark Z. No, I couldn't either. And it's a strange fault, and it says on the job ticket "Advise before going ahead" which says that the owner is not going to want to shell out the amount of labour cost to try and find the problem without the benefit of schematics. I asked the store that took it in, and they confirmed that the owner "didn't want to spend a lot" so I will leave it this coming week in case a schematic comes to light, and then send it back with an 'inspection only' fee attached ... Arfa What is the general type of unit and the fault? It's an amplifier, yes? mz Yep. It's a fairly 'conventional' discrete amp. The complaint was "no audio", but actually it does have audio. Problem is that it is 'thin' and distorted. If you stick a sine wave in, at low levels, it's not far off a sine wave coming out, but as you wind the wick up, it goes more and more towards a sort of spiky triangular square wave. Yes, I know that doesn't make a lot of sense, and is hard to visualize, but then it's also hard to describe. The drive to the output transistors is the same shape near enough, so it's pre-output. It's also on both channels exactly the same. At the volume control and the dual opamp nearby, the waveshape is good. However at a second opamp closer to the output stage, the distortion first appears. Both rails are present and balanced at +/- 18v, but both output pins are sitting at about -12v, and that appears to be the root of the problem. I tried a replacement opamp just in case, but of course, it was the same. I find it odd that both channels are the same. About the only thing I can come up with is the possibility of some fixed bias supply for the stage that is wrong or missing. With a schematic, it would of course be simple to see what was going on ... Arfa |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Req: Need schematic or source to get a schematic for a Bryant 588 gaspack | Home Repair | |||
denon avr-3300...looking for schematic plz or info on fan circuit | Electronics Repair | |||
.Denon PMA-860 | Electronics Repair | |||
:Denon PMA-860 | Electronics Repair | |||
Denon PMA-860 | Electronics Repair |