Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to sci.electronics.repair
|
|||
|
|||
Microwave oven -- Whirlpool MD365WH
Hi,
I have a Whirlpool MD365WH microwave oven. The problem is that the automatic cooking functions is working erratically. If I want to auto-defrost something the display reads out "Sense" and after about one minute, when the program ends, the food is still frozen. But sometimes it work perfectly, and sometimes as described above. The hot air function is sometimes also working in mysterious ways. If I open the door during cooking, the oven keeps running, but not always. I guess the correct behavior should be to immidiately shut off when the door is opened. Sometimes the controlpanel does not respond when I press the buttons. As I belive the problem stems from a faulty control panel, and I have checked and done some resoldering at the controlpanel circuit board, but unfortunately it had no effect. Does someone here have any experience troubleshooting the electronics (or perhapts schematics) in said microwave oven? Kind regards, Marcus Lindahl (Sweden) |
#2
Posted to sci.electronics.repair
|
|||
|
|||
Microwave oven -- Whirlpool MD365WH
Marcus Lindahl wrote:
Hi, I have a Whirlpool MD365WH microwave oven. The problem is that the automatic cooking functions are working erratically. If I want to auto-defrost something, the display reads out "Sense" and after about one minute, when the program ends, the food is still frozen. But sometimes it works perfectly, and sometimes as described above. The hot air function is sometimes also works in mysterious ways. If I open the door during cooking, the oven keeps running, but not always. I guess the correct behavior should be to immediately shut off when the door is opened. This means the door interlock switches are failing. Sometimes the control panel does not respond when I press the buttons. As I believe the problem stems from a faulty control panel, and I have checked and done some resoldering at the control panel circuit board, but unfortunately it had no effect. Does someone here have any experience troubleshooting the electronics (or perhaps schematics) in said microwave oven? Kind regards, Marcus Lindahl (Sweden) http://www.repairfaq.org/REPAIR/ -- 1PW |
#3
Posted to sci.electronics.repair
|
|||
|
|||
Microwave oven -- Whirlpool MD365WH
Hi IPW and thank you for your reply.
Please let me elaborate a bit on the behavior during the hot air function. If I open the door during the hot air function the oven runs for about 3-5 sec before it stops, therefore I belive that heating, fans and the rotating plate is relay controlled by the microprocessor and that the interlocks only shuts down the magnetron (I´m not sure though). Or is it possible that glitching interlocks can cause all these kind of erratic behavior, possibly confusing the microprocessor? Kind regards, Marcus Lindahl 1PW wrote: Marcus Lindahl wrote: Hi, I have a Whirlpool MD365WH microwave oven. The problem is that the automatic cooking functions are working erratically. If I want to auto-defrost something, the display reads out "Sense" and after about one minute, when the program ends, the food is still frozen. But sometimes it works perfectly, and sometimes as described above. The hot air function is sometimes also works in mysterious ways. If I open the door during cooking, the oven keeps running, but not always. I guess the correct behavior should be to immediately shut off when the door is opened. This means the door interlock switches are failing. Sometimes the control panel does not respond when I press the buttons. As I believe the problem stems from a faulty control panel, and I have checked and done some resoldering at the control panel circuit board, but unfortunately it had no effect. Does someone here have any experience troubleshooting the electronics (or perhaps schematics) in said microwave oven? Kind regards, Marcus Lindahl (Sweden) http://www.repairfaq.org/REPAIR/ |
#4
Posted to sci.electronics.repair
|
|||
|
|||
Microwave oven -- Whirlpool MD365WH
Marcus Lindahl wrote:
Hi 1PW and thank you for your reply. Please let me elaborate a bit on the behavior during the hot air function. If I open the door during the hot air function the oven runs for about 3-5 sec before it stops, therefore I believe that heating, fans and the rotating plate is relay controlled by the microprocessor and that the interlocks only shuts down the magnetron (I´m not sure though). One would believe that the door interlocks function for all modes. However your observation & theory may be quite accurate. Truthfully though I don't know what normal operation is for your particular model. Or is it possible that glitching interlocks can cause all these kind of erratic behavior, possibly confusing the microprocessor? Kind regards, Marcus Lindahl The URL I sent you, in the previous post, might be helpful. Erratic behavior may sometimes be traced to intermittent grounds or power supplies going bad. -- 1PW |
#5
Posted to sci.electronics.repair
|
|||
|
|||
Microwave oven -- Whirlpool MD365WH
Erratic behavior may sometimes be traced to intermittent
grounds or power supplies going bad. I've seen this in other electronics (not microwave ovens). You said the problems were intermittent. Is the oven more likely to work correctly when it's cold (that is, it hasn't been used for several hours), or do the problems occur at any time, whether or not the oven has been used? If the oven usually works correctly when "cold", I would start looking at the power supply, especially the capacitors. |
#6
Posted to sci.electronics.repair
|
|||
|
|||
Microwave oven -- Whirlpool MD365WH
Hi!
If I open the door during the hot air function the oven runs for about 3-5 sec before it stops, therefore I belive that heating, fans and the rotating plate is relay controlled by the microprocessor and that the interlocks only shuts down the magnetron (I´m not sure though). I've never seen a properly functioning microwave oven where *any* part of the oven continued to operate if the door was open. It seems to me like letting any part of the oven continue to operate might alarm the end user at the very least. However, I have seen a Sharp oven with a bad door switch that would start its fan (and maybe the turntable as well) whenever the door was opened and the oven was off. Replacing the one bad switch cured the problem entirely, and the oven works fine to this day. Or is it possible that glitching interlocks can cause all these kind of erratic behavior, possibly confusing the microprocessor? This is something that you should examine. However, please do consider the fact that a microwave oven is easily the most dangerous appliance you have in your house due to the high voltage. With its power cord unplugged and the capacitor discharged, the oven will be inert...unless of course, you drop it on your foot. If that fails, I'd make sure that the sensors used in the cooking process are clean, and I'd also consider cleaning the control board. Many ovens don't protect it from food vapors and grease. If that stuff got on the board, it could be shorting out and messing up all kinds of signals going to the controller. I don't think it would harm anything to simply wash the control board in warm soapy water as long as you let it have a day or two in a sunny window to dry out. Rotate it periodically so that a different side faces the window. William |
#7
Posted to sci.electronics.repair
|
|||
|
|||
Microwave oven -- Whirlpool MD365WH
On Oct 8, 8:41*am, "William R. Walsh" wrote:
Hi! If I open the door during the hot air function the oven runs for about 3-5 sec before it stops, therefore I belive that heating, fans and the rotating plate is relay controlled by the microprocessor and that the interlocks only shuts down the magnetron (I´m not sure though). I've never seen a properly functioning microwave oven where *any* part of the oven continued to operate if the door was open. It seems to me like letting any part of the oven continue to operate might alarm the end user at the very least. However, I have seen a Sharp oven with a bad door switch that would start its fan (and maybe the turntable as well) whenever the door was opened and the oven was off. Replacing the one bad switch cured the problem entirely, and the oven works fine to this day. Or is it possible that glitching interlocks can cause all these kind of erratic behavior, possibly confusing the microprocessor? This is something that you should examine. However, please do consider the fact that a microwave oven is easily the most dangerous appliance you have in your house due to the high voltage. With its power cord unplugged and the capacitor discharged, the oven will be inert...unless of course, you drop it on your foot. If that fails, I'd make sure that the sensors used in the cooking process are clean, and I'd also consider cleaning the control board. Many ovens don't protect it from food vapors and grease. If that stuff got on the board, it could be shorting out and messing up all kinds of signals going to the controller. I don't think it would harm anything to simply wash the control board in warm soapy water as long as you let it have a day or two in a sunny window to dry out. Rotate it periodically so that a different side faces the window. William I don't know that particular model, but sometimes the flexible ribbon cable that connects the keypad to the main controller printed circuit board has intermittent contacts. Have you checked this by reseating the cable? |
#8
Posted to sci.electronics.repair
|
|||
|
|||
Microwave oven -- Whirlpool MD365WH
|
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
WTD: List of Whirlpool Fault Codes / Error Codes for Oven / Microwave | Electronics Repair | |||
WTD: List of Whirlpool Fault Codes / Error Codes for Oven / Microwave | Home Repair | |||
whirlpool microwave hood combination | Electronics Repair | |||
Samsung Microwave & GE Microwave oven | Electronics Repair | |||
Help ? microwave repair WHIRLPOOL AVM 230 | Electronics Repair |