 |
|
| Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to sci.electronics.repair
|
|||
|
|||
Tektronics 464 - Sweep generator problem
My Tektronix 464 does not generate any sweep. X-Y is ok, voltages are ok.
Is it normal, that U980 (sweep control IC) is getting "hot"? I can hardly touch it for more than a few seconds. I can see the trigger signal at pin1 of U980 but no other signal except DC-levels on any other pin. Thanks for any hint, Falk |
|
#2
Posted to sci.electronics.repair
|
|||
|
|||
|
Tektronics 464 - Sweep generator problem
Falk Willberg wrote in
: My Tektronix 464 does not generate any sweep. X-Y is ok, voltages are ok. Is it normal, that U980 (sweep control IC) is getting "hot"? I can hardly touch it for more than a few seconds. it should not be that hot. I can see the trigger signal at pin1 of U980 but no other signal except DC-levels on any other pin. Thanks for any hint, Falk -- Jim Yanik jyanik at kua.net |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Wavetek Sweep Generator Model 2005 Schematic / Service Manual | Electronics Repair | |||
| REQ: Info, Manuals, schematics, for Lectrotech Sweep Marker Generator SMG-39 | Electronics Repair | |||
| Schematic or manual for Mercer 9805 Sweep/Function Generator | Electronics Repair | |||
| Problem with vertical sweep on Toshiba CF2665K TV Set | Electronics Repair | |||
| likom l7052 vertical sweep problem | Electronics Repair | |||
Linear Mode
