Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
Samsung 43" rear projection.
Dead, won't come on, led is on at standby, & just flashes at turn with
remote, indicating SMPS is ok, & getting signal to turn on. Unplug connector CNZ04 from convergence, pop in speakers, tries to start, but shuts right down. Sanyo STK 394-250 IC's seem ok, & all fusible resistors check fine. Can't get at the board to do measurements, without removing it totally. No leaks. Anything common on this model? Dani. |
#2
Posted to sci.electronics.repair
|
|||
|
|||
Samsung 43" rear projection.
Model # HC-R4351WX/XZC. Chassis # P60B
Dead, won't come on, led is on at standby, & just flashes at turn with remote, indicating SMPS is ok, & getting signal to turn on. Unplug connector CNZ04 from convergence, pop in speakers, tries to start, but shuts right down. Sanyo STK 394-250 IC's seem ok, & all fusible resistors check fine. Can't get at the board to do measurements, without removing it totally. No leaks. Anything common on this model? Dani. |
#3
Posted to sci.electronics.repair
|
|||
|
|||
Samsung 43" rear projection.
Dani wrote:
Model # HC-R4351WX/XZC. Chassis # P60B Dead, won't come on, led is on at standby, & just flashes at turn with remote, indicating SMPS is ok, & getting signal to turn on. Unplug connector CNZ04 from convergence, pop in speakers, tries to start, but shuts right down. Sanyo STK 394-250 IC's seem ok, & all fusible resistors check fine. Can't get at the board to do measurements, without removing it totally. No leaks. Anything common on this model? Dani. Sure, Check the HOT Section and fly back maybe! -- "I'd rather have a bottle in front of me than a frontal lobotomy" http://webpages.charter.net/jamie_5 |
#4
Posted to sci.electronics.repair
|
|||
|
|||
Samsung 43" rear projection.
Check the set throughly for possible leaks from the crt coolant chambers.
"Meat Plow" wrote in message ... On Thu, 29 Nov 2007 16:17:17 -0800, Dani wrote: Dead, won't come on, led is on at standby, & just flashes at turn with remote, indicating SMPS is ok, & getting signal to turn on. Unplug connector CNZ04 from convergence, pop in speakers, tries to start, but shuts right down. Sanyo STK 394-250 IC's seem ok, & all fusible resistors check fine. Can't get at the board to do measurements, without removing it totally. No leaks. Anything common on this model? Dani. Convergence IC, common problem. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Samsung rear projection TV. | Electronics Repair | |||
Samsung rear projection. | Electronics Repair | |||
RCA 52" rear projection TV. | Electronics Repair | |||
Samsung 48" rear projection TV Model No. SP48T5HP | Electronics Repair | |||
Yellow/bluw "ghost" in SONY 53'' XBR45 (rear projection unit) | Electronics Repair |