Samsung 43" rear projection.
Dead, won't come on, led is on at standby, & just flashes at turn with
remote, indicating SMPS is ok, & getting signal to turn on. Unplug connector CNZ04 from convergence, pop in speakers, tries to start, but shuts right down. Sanyo STK 394-250 IC's seem ok, & all fusible resistors check fine. Can't get at the board to do measurements, without removing it totally. No leaks. Anything common on this model? Dani. |
Samsung 43" rear projection.
Model # HC-R4351WX/XZC. Chassis # P60B
Dead, won't come on, led is on at standby, & just flashes at turn with remote, indicating SMPS is ok, & getting signal to turn on. Unplug connector CNZ04 from convergence, pop in speakers, tries to start, but shuts right down. Sanyo STK 394-250 IC's seem ok, & all fusible resistors check fine. Can't get at the board to do measurements, without removing it totally. No leaks. Anything common on this model? Dani. |
Samsung 43" rear projection.
Dani wrote:
Model # HC-R4351WX/XZC. Chassis # P60B Dead, won't come on, led is on at standby, & just flashes at turn with remote, indicating SMPS is ok, & getting signal to turn on. Unplug connector CNZ04 from convergence, pop in speakers, tries to start, but shuts right down. Sanyo STK 394-250 IC's seem ok, & all fusible resistors check fine. Can't get at the board to do measurements, without removing it totally. No leaks. Anything common on this model? Dani. Sure, Check the HOT Section and fly back maybe! :) -- "I'd rather have a bottle in front of me than a frontal lobotomy" http://webpages.charter.net/jamie_5 |
Samsung 43" rear projection.
Check the set throughly for possible leaks from the crt coolant chambers.
"Meat Plow" wrote in message ... On Thu, 29 Nov 2007 16:17:17 -0800, Dani wrote: Dead, won't come on, led is on at standby, & just flashes at turn with remote, indicating SMPS is ok, & getting signal to turn on. Unplug connector CNZ04 from convergence, pop in speakers, tries to start, but shuts right down. Sanyo STK 394-250 IC's seem ok, & all fusible resistors check fine. Can't get at the board to do measurements, without removing it totally. No leaks. Anything common on this model? Dani. Convergence IC, common problem. |
All times are GMT +1. The time now is 07:36 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter