 |
|
| Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to sci.electronics.repair
|
|||
|
|||
4-pin internal power cord needed for LCD TV
hello, I have a viewsoni N2700w LCD. The power cable that runs from
the VISIONBANK board to power the LCD panel shorted out because the protective sheath was touching some metal on the inside of the case. I have linked some pictures of the problem, and if I was able to get a replacement power cable, everything would work fine. Is there a place i can obtain this cable, or what do i need to do in order to make the cable myself? Could i just cut off the melted 4-pin connector and solder the cables right to the 4 pins? I've included pictures of the unit before I took out the cable that's been burnt, and an image of the cable by itself. http://www.thejet.net/viewsonic/cable_needed_1.jpg http://www.thejet.net/viewsonic/cable_needed_2.jpg http://www.thejet.net/viewsonic/cable_needed_3.jpg http://www.thejet.net/viewsonic/cable_needed_4.jpg Thanks for any help! |
|
#2
Posted to sci.electronics.repair
|
|||
|
|||
|
4-pin internal power cord needed for LCD TV
wrote in message ups.com... hello, I have a viewsoni N2700w LCD. The power cable that runs from the VISIONBANK board to power the LCD panel shorted out because the protective sheath was touching some metal on the inside of the case. I have linked some pictures of the problem, and if I was able to get a replacement power cable, everything would work fine. Is there a place i can obtain this cable, or what do i need to do in order to make the cable myself? Could i just cut off the melted 4-pin connector and solder the cables right to the 4 pins? I've included pictures of the unit before I took out the cable that's been burnt, and an image of the cable by itself. http://www.thejet.net/viewsonic/cable_needed_1.jpg http://www.thejet.net/viewsonic/cable_needed_2.jpg http://www.thejet.net/viewsonic/cable_needed_3.jpg http://www.thejet.net/viewsonic/cable_needed_4.jpg Thanks for any help! Just cut off the end and solder the wires, or put a new connector on it, looks like a standard Molex plug. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| I STRANGLED A CAT WITH A POWER CORD | Home Repair | |||
| hp power cord | Electronics Repair | |||
| How Long Of A Power Cord? | Woodworking | |||
| How Long Of A Power Cord? | Metalworking | |||
Linear Mode
