Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
HP6024 Power Supply Problem
Hi,
i have an HP6024A power supply. The unit run ok only with a variac ( instaed of mains line)and with disconnected Ground(earth) wire. If i connect the unit direclty at mains line with Ground my general switch (on mains) fall everitime. What can be? Thanks |
#2
Posted to sci.electronics.repair
|
|||
|
|||
HP6024 Power Supply Problem
Unplug the PS from the wall and use an ohmmeter on the plug. There
shoul dbe many many megohms resistance between either side of the line and the ground prong. Most common problem is a bad or damp line filter capacitor or a bad or damp transformer. If the breaker is a GFCI type, sometimes a too-large line filter capacitor can cause it to trip. Anything over 0.02uF can cause some GFCI's to trip. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
PowerMac G4 (Quicksilver) Power Supply | Electronics Repair | |||
Strange power problem with Sharp Mid-Drive VCR VC-H86 | Electronics Repair | |||
part II: pc power supply failure | Electronics Repair | |||
OT Guns more Guns | Metalworking | |||
Power supplies are burning out | Electronics Repair |