Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
RCA F25432 Convergence
Looking for some info on setting the convergence on this beast. Any
assistance would be very much appreciated! Thanks, Kemikal |
#2
Posted to sci.electronics.repair
|
|||
|
|||
RCA F25432 Convergence
Many of the RCA sets used a bonded yoke to the CRT. The convergence was
factory set with a tape-magnet on the back of the neck. Once the purity and convergence was factory set, it is no longer adjustable. There are some ways to sort of offset it with some strip magnets, but this is a lot of work, and would require the skills of someone who is very experienced. As the CRT and the scan circuits age, the convergence may change a little. The errors would be more noticeable in the corners. It is not worth to invest time and money in to one of these older sets. -- Jerry G. wrote in message ps.com... Looking for some info on setting the convergence on this beast. Any assistance would be very much appreciated! Thanks, Kemikal |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Toshiba Rear Projection Convergence board problem | Electronics Repair | |||
Toshiba convergence (and an idea) | Electronics Repair | |||
MItsubishi VS60609 No convergence correction | Electronics Repair | |||
Convergence on PTV-375 | Electronics Repair | |||
PTK195 convergence woes, intermittent of course | Electronics Repair |