i've seen where an unplugged hor. connector on a yoke on a conventional
chassis might cause this but anyone have any ideas about what might be
going on on this projo? I'm going over there tomorrow morning to look
at it and any info beforehand would be most sincerely appreciated.
Thanks very much, Lenny Stein, Barlen Electronics.

Loss of horiz deflection, yoke return cap open, yoke horiz winding(s)
improperly connected or open, etc. Normally the set should shut down there
were no horiz deflection. Possibility of crt burns also if set ran for any
length of time after failure.
wrote in message
s.com...
i've seen where an unplugged hor. connector on a yoke on a conventional
chassis might cause this but anyone have any ideas about what might be
going on on this projo? I'm going over there tomorrow morning to look
at it and any info beforehand would be most sincerely appreciated.
Thanks very much, Lenny Stein, Barlen Electronics.