Home |
Search |
Today's Posts |
![]() |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
LinkBack | Thread Tools | Display Modes |
#11
![]()
Posted to sci.electronics.repair,alt.engineering.electrical,alt.horology,uk.d-i-y
|
|||
|
|||
![]()
Ralph Mowery wrote:
Can't say about the UK but in the US the clocks that run only on the power grid and depend on the frequency are very accurate over a long period of time. I would say more like less than a minuit or less over a year period of time if the clock its self is up to it. During periods of peak loads the nominal 60 hz may go down a cycle or so and when the load is taken away the power company will raise the frequency long enough to get the clocks back in time. I read an article a few years ago that discussed how the frequency is regulated in the US. I can't find it now. I think it was by David Mills from the University of Delaware. As I reacall, there are 2 power grids in the US. The Eastern grid is controlled by an automated system at some power plant in Ohio. The Western grid is controlled manually. I wish I could find the article, it had some interesting stuff. Things are probably done in a similar fashion in the UK. - Mooron |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Choosing a HOT WATER RECIRCULATOR for QUICK HOT WATER DELIVERY or for HOT WATER ON D'MAND is now a whole lot easier. | Home Repair | |||
To anyone sick of alt.hvac | Home Repair | |||
Heat banks (again!) | UK diy | |||
CM67 Optimum Start algorithm | UK diy | |||
testing ATX power supply | Electronics Repair |