Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
low ESR cap question & vertical deflection ...
"Leon Kiriliuk" wrote in message news My old "monitor" has a vertical deflection problem. I've noticed one of the caps leaked. (the problem was the top 1/2 stretched, while the bottom shrunk.. until the tube got warm.. but stayed almost the same). According to the net, it's either Marcom or Elna caps (1uF 50V 105 degrees electrolytic). So I went and put in there a 1uF 200V 105 degrees electrolytic. Now the picture is shrunk to the middle 1/3 of the screen! These caps are used to drive a AN5521. If I replace the IC, should that fix my problem? are there any equivalent drop in IC's in case I can't find it local to me? Better yet, what are "low-esr" caps, and how can I tell them when purchasing? Do I have to replace the 2 caps with the exact same "red" caps, or are the ones I put in there now good enough? Thanks! Replacing the IC isn't going to fix it; you still have cap problems. Mark Z. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
LA78040N Input Pin, Sanyo TV DS19204 Vertical Deflection Problem | Electronics Repair | |||
Sanyo TV DS19204, ch 19204-01 Vertical Deflection Problem | Electronics Repair | |||
How to use Sams' Photofact. and vertical deflection problem. | Electronics Repair | |||
Bright Vertical Line on TV | Electronics Repair | |||
Sanyo DS31590 vertical problem | Electronics Repair |