Thread
:
Miter on Crown Molding, 70 degree??????
View Single Post
#
11
evodawg
Posts: n/a
Miter on Crown Molding, 70 degree??????
wrote:
Lou:
When I trim out a house, I always, no exceptions, cope inside corners
of crown.
With flat moldings, I cope if I have to, but occasionally get lucky on
one or two joints in a room and don't have to cope every one.
Robert
I use a special jig with crown, it sets the spring angle and I only cut from
the left side of the miter saw. No moving the miter saw back and forth. The
jig is called CutNcrown. I measure the wall length and it comes out perfect
every time.
http://www.cutncrown.com/
Takes have the time and I never get
any waste from a screw up.
Rich
--
"you can lead them to LINUX
but you can't make them THINK"
Reply With Quote