SDS drill for general DIY?
"John Rumm" wrote in message
...
IMM wrote:
I have used my Makita SDS for screwdriving. It has the power and low
speed torque, but the main problem is actually the length - by the
time
you have a conventional chuck in there with a hex bit holder the end
of
the drill is a long way away. Hence less natural to use for this task.
I used an SDS on 6 inch screws. The screws were in a floor, so no
problem
holding the drill. The low speed and torque ensures the screw is well
screwed in.
Oh dear - I think I am agreement with IMM on something
Law of averages - he changes his mind on things so much eventually you're
bound to.
|