SDS drill for general DIY?
G&M wrote:
What diameter is the NuTool, how long a travel does it have and what's the
rough cost ?
It's a 10", and it'll cut 10" wide board in one pass. It was £140. The
blade that came with it was truly crap, and was replaced with screwfix
11204 pretty soon after purchasing - makes a *huge* difference.
Haven't seen it around, though I do have a passable small router from them.
It came from a small local tool shop. TBH the quality isn't much better
than PPPoo stuff - but if you only want it for rough cuts it's great.
Apart from the poor blade, the rear cutting guide was quite poorly
attached to the table, so a couple of extra screws and some threadlock
were in order.
--
Grunff
|