On Mon, 26 Sep 2005 15:46:06 GMT, "Cyrille de Brébisson"
wrote:

I need to make 350lf of tongue and grove in Jatoba (356 of tongue, 350 of
grove), and was wondering what was the best approach?


so, what are your suggestions?

It might depend on how much detail you want the T&G to have. Do you
need a bevel at the joint or just a simple square T&G. If it's just a
simple square T&G it could be cut easily with a table saw assuming the
material is not to hard to handle.
If you need to buy bits or cutters I would suggest calling the local
millwork to see what they would charge you to run it. They will have
T&G cutters and if the material is clean and straight (so they don't
have to spend time prepping it) the cost might not be prohibitive. I
would guess not much more than a couple of bits and a new router if
you happen to burn yours up.

Mike O.