Thread
:
Brass Rods & Fittings.
View Single Post
#
10
DoN. Nichols
Posts: n/a
According to Gerald Miller :
On 19 Sep 2005 21:39:56 GMT,
(DoN. Nichols)
wrote:
If you're very careful with lots of rocking to and fro, you can force
a 6-32 die onto 1/8" brass (I've done it), but it's highly likely
that you'll just shear the rod off. in the tap.
You mean "in the die"?
If you've got a lathe, I would suggest turning the 1/8" brass
down to 0.138" for the threads, plus a very short area down to 0.107" to
help start the die straight.
Good Luck,
DoN.
I would like to have this kind of lathe to fix some of my "oops cuts"
You mean you haven't learned why lathes can run in reverse? :-)
Enjoy,
DoN.
--
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---
Reply With Quote