Thread
:
Searching for threaded sleeve
View Single Post
#
7
jim rozen
Posts: n/a
In article .com,
says...
thanks for the info so far, I should say that I am looking for 100 of
these, so turning the OD on the hex nuts is not too attractive at that
quantity. I have been drilling & threading cold rolled round bar, but
that gets old quick, too. keep any ideas coming!
That's easier than drilling and tapping from scratch!
I would say you could do a hundred of those in about 1/2 hour
or less. Just run the nuts onto a piece of threaded rod, and
turn ten of them at a shot.
Jim
--
==================================================
please reply to:
JRR(zero) at pkmfgvm4 (dot) vnet (dot) ibm (dot) com
==================================================
Reply With Quote