Fred wrote:
I purchased a new set of Costco Mastergrip Titanium Forstner bits sizes form
1/4" to 2 1/8". This set looks very nice until I pullout a small 3/8" bit,
put it in my hand drill and proceeded to drill. I need to go through a
laminate flooring (about 1/4" thick) and 1/2" particle board below it. After
one minute I just got through the top skin of the laminate then it won't go
beyond the particle board. I put all my 180 pounds on the drill and nothing.
I then took out my high speed twist bit and drill through like butter and
then rim out with the Forstner. The Titanium on the cutting surface is gone
from the friction. I've drilled through laminates with my hole saw before
without any problems. I had other Fostner bits, not Mastergrip, on the drill
press and its slow going but it does the job. Tell me Forstner bits are not
efficient but not like this.


I think it is operator error--the drill is running
in reverse. Even a nail will drill faster than
that. But if it is truly a bad bit, no problem
just take the set back to Costco for a refund.